1 plc 0 plc 2 plc 3 plc 4 plc dimensions: tolerances unless otherwise specified: angles weight application spec product spec of material finish dwn chk apvd name size cage code drawing no scale sheet rev loc dist released for publication c copyright all rights reserved. this drawing is unpublished. revisions p ltr date dwn apvd description 1469-35 (3/11) a4 restricted to this drawing is a controlled document. te connectivity a revised per ecr-14-007823 02jun2014 rs ec b eco-15-015144: add ul. 03nov2015 ec ec customer drawing 8-1609148-9 rs 13dec2013 ec 13dec2013 ec 13dec2013 1:1 1 1 b - - - - - mm 2 1 0.5 0.2 0.0001 - - - 600aph12p 3-phase delta filter - 20 20 00779 by - 12 260 235 300 40 25 10.5 25 40 37 150 210 45 60 8 * 12 30 140 100 mhz 0.01 0.05 0.15 0.5 1.0 3.0 5.0 10 30 cm 11 25 68 88 72 70 60 43 24 dm 31 43 71 73 62 50 45 38 27 line load * do not loosen inner ground nuts. torque outer ground nuts to: 25-30 nm [220-260 in-lb] safety organizations this filter has been formally recognized, certified or approved by the listed agency. therefore, all test/requirements specified in the latest revision of the following agency standards have been met: ul operating specifications line current/voltage: 600 a, 690 vac line frequency: 50-60 hz nominal leakage current: 10 ma maximum leakage current: 330ma @ 400v, 50hz operating ambient temperature range @ rated current, i : -10$c to +50$c in an ambient, t , higher than 50c, the maximum operating 100 - t current, i , is as follows: i = i 50 r o q reliability specifications storage temperature: -40$c to +85$c humidity: 21 days @ 40$c and 95% rh test specifications inductance, nominal: 88.7 h capacitance @ 1 khz, 0.25 vac max., 25$c #1$c: line to ground, nominal: 2.62 f line to line, nominal: 11.9 f discharge resistor l/g and l/l i.r. 666k^/666k^ ir (no discharge resistor) 20c, 50% rh and 100vdc, min: 6000m^ recommended receiving inspection hipot line to ground for 1 minute: 2640 vdc line to line for 1 minute: 2520 vdc filter approval: the best way to select and qualify a filter is for your engineering to test the unit in your equipment. typical insertion loss common mode 50/50 ^; differential mode 100/100 ^
|
